Home › ENGINE ยท 1GR-FE › ENGINE MECHANICAL › FRONT CRANKSHAFT OIL SEAL

FRONT CRANKSHAFT OIL SEAL > REMOVAL

for Preparation Click here



1. REMOVE RADIATOR ASSEMBLY
  1. Remove the radiator (Click here).



2. REMOVE CRANKSHAFT PULLEY


    A072945E01
  1. Turn the crankshaft pulley, and align the notch with the timing mark "0" of the timing chain cover.



    G038065E10
  1. Check that the timing marks of the camshaft timing gears and sprockets are aligned with the timing marks of the bearing caps as shown in the illustration.



    A072947E03
  1. Using SST, hold the crankshaft pulley and loosen the pulley set bolt.

    SST
    09213-54015   (91651-60855)
    09330-00021  



    A072948E01
  1. Using the pulley set bolt and SST, remove the crankshaft pulley.

    SST
    09950-50013   (09951-05010, 09952-05010, 09953-05020, 09954-05030)



3. REMOVE FRONT CRANKSHAFT OIL SEAL


    A076330E01
  1. Using a screwdriver, pry out the oil seal.

    NOTICE:
    Be careful not to damage the crankshaft. Wrap the tip of the screwdriver with tape.