Home › ENGINE ยท 1GR-FE › ENGINE MECHANICAL › REAR CRANKSHAFT OIL SEAL

REAR CRANKSHAFT OIL SEAL > INSTALLATION

for Preparation Click here



1. INSTALL REAR CRANKSHAFT OIL SEAL


    A076329E01
  1. Apply MP grease to a new oil seal lip.

  1. Using SST and a hammer, tap in the oil seal until its surface is flush with the rear oil seal retainer edge.

    SST
    09223-78010  



2. INSTALL DRIVE PLATE AND RING GEAR


    A076326E05
  1. Using SST, hold the crankshaft.

    SST
    09213-54015   (91651-60855)
    09330-00021  

  1. Temporarily install the front spacer, drive plate and rear spacer with the 8 bolts.



    A151280E01
  1. Tighten the 8 bolts uniformly in several steps in the order shown in the illustration.

    Torque:
    83 N*m{ 46 kgf*cm , 61 ft.*lbf }

    NOTICE:
    Do not start the engine for at least 1 hour after installing.



3. INSTALL AUTOMATIC TRANSMISSION ASSEMBLY
  1. Install the automatic transmission (Click here).