INTUITIVE PARKING ASSIST SYSTEM > Front Clearance Sonar Sensor RH Circuit |

| 1.REPLACE FRONT CORNER NO. 1 ULTRASONIC SENSOR RH |
Replace the ultrasonic sensor with a normally functioning sensor (Click here).
| NEXT | |
| 2.CHECK HARNESS AND CONNECTOR (FRONT CORNER SENSOR RH - ECU) |
![]() |
Disconnect the B1 sensor connector.
Disconnect the J35 ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| B1-1 (BI) - J35-9 (BOF) | Always | Below 1 Ω |
| B1-3 (SI) - J35-7 (SOF) | Always | Below 1 Ω |
| B1-5 (EI) - J35-23 (E1) | Always | Below 1 Ω |
| B1-1 (BI) - Body ground | Always | 10 kΩ or higher |
| B1-3 (SI) - Body ground | Always | 10 kΩ or higher |
| B1-5 (EI) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||