Home › BODY ELECTRICAL › PARK ASSIST / MONITORING › INTUITIVE PARKING ASSIST SYSTEM

INTUITIVE PARKING ASSIST SYSTEM > Rear Clearance Sonar Sensor RH Circuit

for Preparation Click here


DESCRIPTION

The ultrasonic sensor sends and receives ultrasonic waves. Based on the received wave, the sensor calculates the approximate distance value between the vehicle and the obstacle, and sends the distance value as a signal to the clearance warning ECU.

WIRING DIAGRAM


E132019E16


INSPECTION PROCEDURE

1.REPLACE REAR CORNER NO. 1 ULTRASONIC SENSOR RH
  1. Replace the ultrasonic sensor with a normally functioning sensor (Click here).


NEXT


2.CHECK HARNESS AND CONNECTOR (REAR CORNER SENSOR RH - ECU)
B144573E07
  1. Disconnect the S2 sensor connector.

  1. Disconnect the J35 ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    S2-1 (BI) - J35-24 (BOR)
    Always
    Below 1 Ω
    S2-3 (SI) - J35-6 (SOR)
    Always
    Below 1 Ω
    S2-5 (EI) - J35-22 (E2)
    Always
    Below 1 Ω
    S2-1 (BI) - Body ground
    Always
    10 kΩ or higher
    S2-3 (SI) - Body ground
    Always
    10 kΩ or higher
    S2-5 (EI) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)