Home › ENGINE ยท 2UZ-FE › COOLING › WATER PUMP

WATER PUMP > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
  1. After the ignition switch is turned OFF, the navigation system requires approximately 90 seconds to record various types of memory and setting. As a result, after turning the ignition switch OFF, wait 90 seconds or more before disconnecting the cable from the negative (-) battery terminal.
  2. Some systems need to be initialized after the cable is reconnected (Click here).



2. REMOVE NO. 1 ENGINE UNDER COVER


    A150108
  1. Remove the 3 screws and 5 bolts.

  1. Unhook the engine under cover from the vehicle body as shown in the illustration.



3. DRAIN ENGINE COOLANT

CAUTION:
Do not remove the radiator cap while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.

  1. Loosen the radiator drain cock plug and 2 cylinder block drain cock plugs.

  1. Remove the radiator cap. Then drain the coolant.

    HINT:
    Collect the coolant in a container and dispose of it according to the regulations in your area.



  1. Tighten the 2 cylinder block drain cock plugs.

    Torque:
    13 N*m{ 130 kgf*cm , 10 ft.*lbf }



    A156211E01

  1. Tighten the radiator drain cock plug by hand.



4. REMOVE TIMING BELT
  1. For the timing belt, refer to the following procedures .



5. REMOVE WATER INLET HOUSING


    A122973
  1. Disconnect the water by-pass hose from the water inlet housing.

  1. Remove the 2 bolts holding the water inlet housing to the water pump.

  1. Disconnect the water inlet housing from the front water by-pass joint, and remove the water inlet and inlet housing assembly.

  1. Remove the O-ring from the water inlet housing.



6. REMOVE WATER PUMP ASSEMBLY


    A122974
  1. Remove the 5 bolts, 2 stud bolts, nut, water pump and gasket.

  1. Remove the O-ring from the water by-pass pipe.