Home › ENGINE ยท 2UZ-FE › ENGINE MECHANICAL › REAR CRANKSHAFT OIL SEAL

REAR CRANKSHAFT OIL SEAL > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
  1. After the ignition switch is turned OFF, the navigation system requires approximately 90 seconds to record various types of memory and setting. As a result, after turning the ignition switch OFF, wait 90 seconds or more before disconnecting the cable from the negative (-) battery terminal.
  2. Some systems need to be initialized after the cable is reconnected (Click here).



2. REMOVE AUTOMATIC TRANSMISSION ASSEMBLY
  1. for 2WD, refer to the following procedures (Click here).

  1. for 4WD, refer to the following procedures (Click here).



3. REMOVE DRIVE PLATE AND RING GEAR SUB-ASSEMBLY


    A160799E01
  1. Using SST, hold the crankshaft.

    SST
    09213-70011  
    09330-00021  



    A160778
  1. Remove the 8 bolts, front drive plate spacer, drive plate and rear drive plate spacer.



4. REMOVE REAR CRANKSHAFT OIL SEAL


    A160779E01
  1. Using a knife, cut off the lip of the oil seal.

  1. Using a screwdriver, pry out the oil seal.

    NOTICE:
    Do not damage the surface of the oil seal press fit hole and crankshaft.

    HINT:
    Tape the screwdriver tip before use.