Home › ENGINE · 1GR-FE › CHARGING › GENERATOR

GENERATOR > INSTALLATION

for Preparation Click here



1. INSTALL GENERATOR ASSEMBLY


    A152257
  1. Install the generator with the 2 bolts.

    Torque:
    43 N*m{ 438 kgf*cm , 32 ft.*lbf }



    A152256
  1. Install the wire harness clamp bracket with the bolt.

    Torque:
    8.2 N*m{ 84 kgf*cm , 73 in.*lbf }

  1. Install the wire harness clamp to the bracket.

  1. Connect the generator wire with the nut.

    Torque:
    9.8 N*m{ 100 kgf*cm , 87 in.*lbf }

  1. Install the terminal cap.

  1. Connect the generator connector.



    A152255
  1. Install the wire harness clamp bracket with the nut.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }



2. INSTALL FAN AND GENERATOR V BELT


    A076442E02
  1. While turning the belt tensioner counterclockwise, align the holes, and then insert a bar of φ 6 mm (0.236 in.) into the holes to fix the belt tensioner.



  1. Install the fan and generator V belt.

    HINT:
    A151277E01
    If it is hard to install the fan and generator V belt, perform the following procedures.
    1. Put the fan and generator V belt on all parts except the vane pump, as shown in the illustration.
    2. While releasing the belt tension by turning the belt tensioner counterclockwise, put the fan and generator V belt on the vane pump.

  1. While turning the belt tensioner counterclockwise, remove the bar.



3. INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY
  1. Install the engine under cover with the 5 bolts and 3 screws.

    Torque:
    for bolt:
    29 N*m{ 296 kgf*cm , 21 ft.*lbf }
    for screw:
    5.4 N*m{ 55 kgf*cm , 48 in.*lbf }



4. INSTALL V-BANK COVER


    A112983E02
  1. Install the V-bank cover with the 2 nuts.

    Torque:
    7.5 N*m{ 76 kgf*cm , 66 in.*lbf }



5. INSTALL BATTERY


6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
Some systems need to be initialized after the cable is reconnected (Click here).