Home › ENGINE ยท 1GR-FE › CHARGING › GENERATOR

GENERATOR > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
  1. Some systems need to be initialized after the cable is reconnected (Click here).
  2. After the ignition switch is turned OFF, the navigation system requires approximately 90 seconds to record various types of memory and settings. As a result, after turning the ignition switch OFF, wait 90 seconds or more before disconnecting the cable from the negative (-) battery terminal.



2. REMOVE BATTERY


3. REMOVE V-BANK COVER


    A112983E03
  1. Remove the 2 nuts and V-bank cover.



4. REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY
  1. Remove the 5 bolts, 3 screws and engine under cover.



5. REMOVE FAN AND GENERATOR V BELT


    A076441E01
  1. While releasing the belt tension by turning the belt tensioner counterclockwise, remove the fan and generator V belt from the belt tensioner.



6. REMOVE GENERATOR ASSEMBLY


    A152255
  1. Remove the nut and disconnect the wire harness clamp bracket.



    A152256
  1. Disconnect the generator connector.

  1. Remove the terminal cap.

  1. Remove the nut and disconnect the generator wire.

  1. Remove the wire harness clamp.

  1. Remove the bolt and disconnect the wire harness clamp bracket.



    A152257
  1. Remove the 2 bolts and generator.