Home › ENGINE ยท 2UZ-FE › CHARGING › GENERATOR

GENERATOR > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
  1. Some systems need to be initialized after the cable is reconnected (Click here).
  2. After the ignition switch is turned OFF, the navigation system requires approximately 90 seconds to record various types of memory and settings. As a result, after turning the ignition switch OFF, wait 90 seconds or more before disconnecting the cable from the negative (-) battery terminal.



2. REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY


    A150108
  1. Remove the 3 screws and 5 bolts.

  1. Unhook the engine under cover from the vehicle body as shown in the illustration.



3. REMOVE THROTTLE BODY COVER SUB-ASSEMBLY


    A153486
  1. Remove the 2 nuts and throttle body cover.



4. DISCONNECT AIR CLEANER HOSE ASSEMBLY
  1. Disconnect the air cleaner hose from the throttle body.



5. REMOVE FAN AND GENERATOR V BELT


    B000809E02
  1. Loosen the belt tension by turning the belt tensioner counterclockwise, and then remove the fan and generator V belt.

    HINT:
    The pulley bolt for the belt tensioner has left-hand thread.



6. DISCONNECT VANE PUMP ASSEMBLY
  1. Remove the 2 bolts, nut and vane pump.



7. REMOVE GENERATOR ASSEMBLY


    A152261
  1. Disconnect the generator connector.

  1. Remove the terminal cap and nut, and disconnect the generator wire.

  1. Remove the bolt and disconnect the wire harness bracket from the generator.



    A152262
  1. Remove the bolt, 2 nuts and generator.