GENERATOR > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE V-BANK COVER |
![]() |
Raise the front of the V-bank cover to detach the 2 pins. Then remove the 2 V-bank cover hooks from the bracket, and remove the V-bank cover.
| 3. REMOVE AIR CLEANER HOSE ASSEMBLY |
![]() |
Disconnect the vacuum hose and ventilation hose.
Loosen the 2 clamps.
Remove the air cleaner hose.
| 4. REMOVE AIR CLEANER ASSEMBLY |
![]() |
Remove the air cleaner cap.
Disconnect the MAF meter connector.
Using a clip remover, detach the wire harness clamp.
Unfasten the 4 hook clamps and then remove the air cleaner cap.
Remove the air cleaner element.
![]() |
Remove the 2 bolts and air cleaner case.
| 5. REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY |
![]() |
Remove the 3 screws and 5 bolts.
Unhook the engine under cover from the vehicle body as shown in the illustration.
| 6. REMOVE FAN AND GENERATOR V BELT |
![]() |
Loosen the belt tension by turning the belt tensioner counterclockwise, and then remove the fan and generator V belt.
| 7. REMOVE FRONT FENDER APRON SEAL RH |
Remove the 5 clips and apron seal.
| 8. DISCONNECT VANE PUMP ASSEMBLY |
![]() |
Disconnect the 2 clamps and power steering oil pressure switch connector.
![]() |
Remove the 2 bolts and disconnect the vane pump.
| 9. REMOVE GENERATOR ASSEMBLY |
![]() |
Disconnect the generator connector.
Remove the terminal cap and nut, and disconnect the generator wire.
Remove the bolt and disconnect the wire harness bracket from the generator.
![]() |
Remove the 3 bolts, nut and generator.