Home › ENGINE · 3UR-FBE › CHARGING › GENERATOR

GENERATOR > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
  1. When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here)
  2. After the ignition switch is turned off, the navigation system requires approximately 90 seconds to record various types of memory and settings. As a result, after turning the ignition switch off, wait 90 seconds or more before disconnecting the cable from the negative (-) battery terminal.



2. REMOVE V-BANK COVER


    A165576E01
  1. Raise the front of the V-bank cover to detach the 2 pins. Then remove the 2 V-bank cover hooks from the bracket, and remove the V-bank cover.



3. REMOVE AIR CLEANER HOSE ASSEMBLY


    A162102E01
  1. Disconnect the vacuum hose and ventilation hose.

  1. Loosen the 2 clamps.

  1. Remove the air cleaner hose.



4. REMOVE AIR CLEANER ASSEMBLY


    A162105E01
  1. Remove the air cleaner cap.

    1. Disconnect the MAF meter connector.

    2. Using a clip remover, detach the wire harness clamp.

    3. Unfasten the 4 hook clamps and then remove the air cleaner cap.

  1. Remove the air cleaner element.



    A156197E01
  1. Remove the 2 bolts and air cleaner case.



5. REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY


    A150108
  1. Remove the 3 screws and 5 bolts.

  1. Unhook the engine under cover from the vehicle body as shown in the illustration.



6. REMOVE FAN AND GENERATOR V BELT


    A163770E01
  1. While turning the belt tensioner counterclockwise, align the service hole for the belt tensioner and the belt tensioner fixing position, and then insert a bar of φ 5 mm (0.197 in.) into the service hole to fix the belt tensioner in place.

    HINT:
    The pulley bolt for the belt tensioner has a left-hand thread.

  1. Remove the V belt.



7. REMOVE FRONT FENDER APRON SEAL RH
  1. Remove the 5 clips and apron seal.



8. DISCONNECT VANE PUMP ASSEMBLY


    A164433
  1. Disconnect the 2 clamps and power steering oil pressure switch connector.



    A163289
  1. Remove the 2 bolts and disconnect the vane pump.



9. REMOVE GENERATOR ASSEMBLY


    A156405
  1. Disconnect the generator connector.

  1. Remove the terminal cap and nut, and disconnect the generator wire.

  1. Remove the bolt and disconnect the wire harness bracket from the generator.



    A156406
  1. Remove the 3 bolts, nut and generator.