Home › BODY ELECTRICAL › PARK ASSIST / MONITORING › INTUITIVE PARKING ASSIST SYSTEM

INTUITIVE PARKING ASSIST SYSTEM > Vehicle Speed Signal Circuit

for Preparation Click here


WIRING DIAGRAM


E115290E60


INSPECTION PROCEDURE

1.CHECK COMBINATION METER ASSEMBLY (SPEED SIGNAL)
B144640E02
  1. Disconnect the J35 ECU connector.

  1. Using an oscilloscope, check the signal waveform of the meter.
    Item
    Content
    Tester Connection
    J35-3 (SPD) - Body ground
    Tool Setting
    5 V/DIV., 20 msec./DIV.
    Condition
    Drive vehicle at 20 km/h (12 mph)

    OK:
    Refer to the illustration.

    HINT:
    As the vehicle speed increases, the wave length shortens.



NG
Go to step 2
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)  

2.CHECK HARNESS AND CONNECTOR (ECU - METER)
B144641E02
  1. Disconnect the J35 ECU connector.

  1. Disconnect the J28 meter connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    J35-3 (SPD) - J28-35 (+S)
    Always
    Below 1 Ω
    J35-3 (SPD) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

GO TO METER / GAUGE SYSTEM (Click here)