Home › BODY ELECTRICAL › METER › METER / GAUGE SYSTEM

METER / GAUGE SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
  1. Use these procedures to troubleshoot the meter / gauge system.
  2. *: Use the Techstream.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.INSPECT BATTERY VOLTAGE

      Standard voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding.

    NEXT


    3.CHECK FOR DTC*
    1. Check for DTCs and note any codes that are output (Click here).

    2. Delete the DTCs (Click here).

    3. Recheck for DTCs. Based on the DTCs output above, try to force output of the same CAN communication system DTC or meter / gauge system DTC by simulating the symptoms indicated by the DTC.
      Result: 
      Result
      Proceed to
      DTC is not output
      A
      CAN communication system DTC is output
      B
      Meter / gauge system DTC is output
      C



    B.
    Go to CAN COMMUNICATION SYSTEM (Click here)

    C.
    Go to DIAGNOSTIC TROUBLE CODE CHART (Click here)
    A


    4.PROBLEM SYMPTOMS TABLE
    1. Refer to the problem symptoms table (Click here).
      Result: 
      Result
      Proceed to
      Fault is not listed in problem symptoms table
      A
      Fault is listed in problem symptoms table
      B



    B.
    Go to step 6
    A


    5.OVERALL ANALYSIS AND TROUBLESHOOTING*
    1. Terminals of ECU (Click here)

    2. Data List/Active Test (Click here)

    3. Operation check (Click here)


    NEXT


    6.REPAIR OR REPLACE

      NEXT


      7.CONFIRMATION TEST

        NEXT

        END