Home › BODY ELECTRICAL › AUDIO / VISUAL › AUDIO AND VISUAL SYSTEM (for CrewMax)

AUDIO AND VISUAL SYSTEM (for CrewMax) > Cellular Phone Voice Circuit between Radio Receiver and Stereo Component Amplifier

for Preparation Click here


SYSTEM DESCRIPTION

This circuit is used when the cellular phone voice in the "Bluetooth" handsfree system is on.

WIRING DIAGRAM


E146459E01


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (RADIO RECEIVER - STEREO COMPONENT AMPLIFIER)


    E145926E01
  1. Disconnect the K3 receiver connector.

  1. Disconnect the K15 amplifier connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    K3-11 (IVO+) - K15-23 (II1+)
    Always
    Below 1 Ω
    K3-12 (IVO-) - K15-22 (II1-)
    K3-11 (IVO+) - Body ground
    Always
    10 kΩ or higher
    K3-12 (IVO-) - Body ground



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)