Home › ENGINE ยท 2UZ-FE › ENGINE CONTROL SYSTEM › CRANKSHAFT POSITION SENSOR

CRANKSHAFT POSITION SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL CRANKSHAFT POSITION SENSOR


    A153483
  1. Install the sensor with the bolt.

    Torque:
    6.5 N*m{ 65 kgf*cm , 58 in.*lbf }

  1. Connect the sensor connector.



2. INSTALL NO. 1 ENGINE UNDER COVER


    A150108
  1. Hook the engine under cover onto the vehicle body as shown in the illustration.

  1. Install the 3 screws and 5 bolts.

    Torque:
    for bolt:
    29 N*m{ 296 kgf*cm , 21 ft.*lbf }
    for screw:
    5.4 N*m{ 55 kgf*cm , 48 in.*lbf }



3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
Some systems need to be initialized after the cable is reconnected (Click here).