Home › ENGINE ยท 2UZ-FE › ENGINE CONTROL SYSTEM › ECM

ECM > INSTALLATION

for Preparation Click here



1. INSTALL ECM GASKET
  1. Clean the ECM seal's surface with non-residue solvent.

  1. Attach a new gasket to the ECM.



2. INSTALL ECM


    A155993
  1. Install the ECM with the 4 bolts.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }

    NOTICE:
    1. Make sure the gasket is not folded or caught on any area on the surrounding part.
    2. Make sure there is no foreign matter caught between the gasket and surrounding part.
    3. Do not damage the gasket.



    A160064
  1. Connect the 2 ECM connectors and push each lock lever down to lock the ECM connectors.

    NOTICE:
    1. Make sure that the lock lever is raised 90° before connecting the ECM connectors. Failure to do this may cause the lock lever and terminals to break.
    2. Do not twist the wire harness when connecting the ECM connectors.



3. CONNECT CONNECTOR HOLDER BLOCK


    A155992
  1. Install the connector holder block with the 3 bolts.

    Torque:
    7.3 N*m{ 74 kgf*cm , 65 in.*lbf }



4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
Some systems need to be initialized after the cable is reconnected (Click here).