Home › ENGINE ยท 2UZ-FE › ENGINE CONTROL SYSTEM › CAMSHAFT POSITION SENSOR

CAMSHAFT POSITION SENSOR > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
  1. Some systems need to be initialized after the cable is reconnected (Click here).
  2. After the ignition switch is turned OFF, the navigation system requires approximately 90 seconds to record various types of memory and settings. As a result, after turning the ignition switch OFF, wait 90 seconds or more before disconnecting the cable from the negative (-) battery terminal.



2. DRAIN ENGINE COOLANT

CAUTION:
Do not remove the radiator cap while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.

  1. Loosen the radiator drain cock plug and 2 cylinder block drain cock plugs.

  1. Remove the radiator cap. Then drain the coolant.

    HINT:
    Collect the coolant in a container and dispose of it according to the regulations in your area.



  1. Tighten the 2 cylinder block drain cock plugs.

    Torque:
    13 N*m{ 130 kgf*cm , 10 ft.*lbf }



    A156211E01

  1. Tighten the radiator drain cock plug by hand.



3. REMOVE DRIVE BELT


    B000809E02
  1. Loosen the belt tension by turning the belt tensioner counterclockwise, and then remove the fan and generator V belt.

    HINT:
    The pulley bolt for the belt tensioner has left-hand thread.



4. DISCONNECT NO. 1 RADIATOR HOSE


5. REMOVE NO. 3 TIMING BELT COVER SUB-ASSEMBLY LH


    A014424E08
  1. Disconnect the engine wire from the 2 wire clamps.

  1. Disconnect the camshaft position sensor connector.

  1. Disconnect the camshaft position sensor wire from the wire clamp on the timing belt cover.

  1. Remove the wire grommet from the timing belt cover.

  1. Remove the 4 bolts.

  1. Pull the cover outward, pull the camshaft position sensor wire out of the cover, and remove the cover.



6. REMOVE CAMSHAFT POSITION SENSOR


    A134807
  1. Remove the bolt, stud bolt and camshaft position sensor.