Home › STEERING › POWER STEERING › VANE PUMP (for 1GR-FE)

VANE PUMP (for 1GR-FE) > INSTALLATION

for Preparation Click here



1. INSTALL VANE PUMP ASSEMBLY


    F051260E01
  1. Install the vane pump with the 2 bolts.

    Torque:
    28 N*m{ 286 kgf*cm , 21 ft.*lbf }



2. CONNECT PRESSURE FEED TUBE


C158817E01
  1. Install a new gasket to the pressure feed tube.

  1. Install the pressure feed tube with the union bolt.

    Torque:
    51 N*m{ 520 kgf*cm , 38 ft.*lbf }



3. CONNECT POWER STEERING OIL PRESSURE SWITCH CONNECTOR


C158739


4. CONNECT SUCTION HOSE


    C158815E01
  1. Connect the suction hose with the clip.



5. INSTALL FAN AND GENERATOR V BELT


    A076442E02
  1. While turning the belt tensioner counterclockwise, align the holes, and then insert a bar of φ 6 mm (0.236 in.) into the holes to fix the belt tensioner.



  1. Install the fan and generator V belt.

    HINT:
    A151277E01
    If it is hard to install the fan and generator V belt, perform the following procedures.
    1. Put the fan and generator V belt on all parts except the vane pump, as shown in the illustration.
    2. While releasing the belt tension by turning the belt tensioner counterclockwise, put the fan and generator V belt on the vane pump.

  1. While turning the belt tensioner counterclockwise, remove the bar.



6. ADD POWER STEERING FLUID


7. BLEED POWER STEERING FLUID
  1. Check the fluid level.

  1. Jack up the front of the vehicle and support it with stands.

  1. Turn the steering wheel.

    1. With the engine stopped, turn the wheel slowly from lock to lock several times.

  1. Lower the vehicle.

  1. Start the engine.

  1. Run the engine at idle for a few minutes.

  1. Turn the steering wheel.

    1. With the engine idling, turn the wheel left or right to the full lock position and keep it there for 2 to 3 seconds, then turn the wheel to the opposite full lock position and keep it there for 2 to 3 seconds.(*1)

    2. Repeat (*1) several times.

  1. Stop the engine.



    C124274E02
  1. Check for foaming or emulsification.
    If the system has to be bled twice because of foaming or emulsification, check for fluid leaks in the system.

  1. Check the fluid level.



8. INSPECT FOR POWER STEERING FLUID LEAK


9. INSTALL NO. 1 ENGINE UNDER COVER
  1. Install the engine under cover with the 5 bolts and 3 screws.

    Torque:
    for bolt:
    29 N*m{ 296 kgf*cm , 21 ft.*lbf }
    for screw:
    5.4 N*m{ 55 kgf*cm , 48 in.*lbf }



10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
Some systems need to be initialized after the cable is reconnected (Click here).