Home › STEERING › POWER STEERING › VANE PUMP (for 1GR-FE)

VANE PUMP (for 1GR-FE) > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
  1. After the ignition switch is turned OFF, the navigation system requires approximately 90 seconds to record various types of memory and settings. As a result, after turning the ignition switch OFF, wait 90 seconds or more before disconnecting the cable from the negative (-) battery terminal.
  2. Some systems need to be initialized after the cable is reconnected (Click here).



2. REMOVE NO. 1 ENGINE UNDER COVER
  1. Remove the 5 bolts, 3 screws and engine under cover.



3. REMOVE FAN AND GENERATOR V BELT


    A076441E01
  1. While releasing the belt tension by turning the belt tensioner counterclockwise, remove the fan and generator V belt from the belt tensioner.



4. DRAIN POWER STEERING FLUID


5. DISCONNECT SUCTION HOSE


C158815E01


6. DISCONNECT POWER STEERING OIL PRESSURE SWITCH CONNECTOR


C158739


7. DISCONNECT PRESSURE FEED TUBE


    C158817E01
  1. Remove the bolt and disconnect the pressure feed tube.

  1. Remove the gasket.



8. REMOVE VANE PUMP ASSEMBLY


F051260E01
  1. Remove the 2 bolts and vane pump.