Home › STEERING › POWER STEERING › VANE PUMP (for 3UR-FE, 3UR-FBE)

VANE PUMP (for 3UR-FE, 3UR-FBE) > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
Some systems need to be initialized after the cable is reconnected (Click here).



2. REMOVE V-BANK COVER
  1. Remove the 5 bolts, 3 screws and engine under cover.



3. REMOVE AIR CLEANER HOSE ASSEMBLY


    A162102E01
  1. Disconnect the vacuum hose and ventilation hose.

  1. Loosen the 2 clamps.

  1. Remove the air cleaner hose.



4. REMOVE AIR CLEANER ASSEMBLY


    A162105E01
  1. Remove the air cleaner cap.

    1. Disconnect the MAF meter connector.

    2. Using a clip remover, detach the wire harness clamp.

    3. Unfasten the 4 hook clamps and then remove the air cleaner cap.

  1. Remove the air cleaner element.



    A156197E01
  1. Remove the 2 bolts and air cleaner case.



5. REMOVE FAN AND GENERATOR V BELT


    A076441E01
  1. While releasing the belt tension by turning the belt tensioner counterclockwise, remove the fan and generator V belt from the belt tensioner.



6. DRAIN POWER STEERING FLUID


7. DISCONNECT WIRE HARNESS CLAMP


C161008


8. DISCONNECT SUCTION HOSE


C161009E01


9. DISCONNECT POWER STEERING OIL PRESSURE SENSOR CONNECTOR


C161010


10. DISCONNECT PRESSURE FEED TUBE


    C161011E01
  1. Remove the bolt and disconnect the pressure feed tube.

  1. Remove the gasket.



11. REMOVE VANE PUMP ASSEMBLY


C161012
  1. Remove the 2 bolts and vane pump.