Home › STEERING › POWER STEERING › VANE PUMP (for 2UZ-FE)

VANE PUMP (for 2UZ-FE) > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
  1. After the ignition switch is turned OFF, the navigation system requires approximately 90 seconds to record various types of memory and settings. As a result, after turning the ignition switch OFF, wait 90 seconds or more before disconnecting the cable from the negative (-) battery terminal.
  2. Some systems need to be initialized after the cable is reconnected (Click here).



2. REMOVE NO. 1 ENGINE UNDER COVER
  1. Remove the 5 bolts, 3 screws and engine under cover.



3. REMOVE THROTTLE BODY COVER SUB-ASSEMBLY


    A153486
  1. Remove the 2 nuts and throttle body cover.



4. REMOVE AIR CLEANER ASSEMBLY WITH AIR CLEANER HOSE
  1. Disconnect the MAF meter connector.

  1. Disconnect the hoses.

  1. Remove the clamp.

  1. Remove the 2 bolts and air cleaner with air cleaner hose connected.



5. DRAIN POWER STEERING FLUID


6. REMOVE FAN AND GENERATOR V BELT


    B000809E02
  1. Loosen the belt tension by turning the belt tensioner counterclockwise, and then remove the fan and generator V belt.

    HINT:
    The pulley bolt for the belt tensioner has left-hand thread.



7. DISCONNECT NO. 2 VENTILATION HOSE
  1. Disconnect the ventilation hose from the air cleaner.



8. DISCONNECT VACUUM HOSE


9. DISCONNECT RETURN HOSE


C158816
  1. Detach the clip and disconnect the return hose.



10. DISCONNECT POWER STEERING OIL PRESSURE SENSOR CONNECTOR


C158740


11. DISCONNECT PRESSURE FEED TUBE


C158818
  1. Remove the bolt and disconnect the pressure feed tube.

  1. Remove the gasket.



12. REMOVE VANE PUMP ASSEMBLY
  1. Remove the 2 bolts, nut and vane pump.