Home › STEERING › POWER STEERING › POWER STEERING GEAR

POWER STEERING GEAR > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
  1. After the ignition switch is turned off, the navigation system requires approximately 90 seconds to record various types of memory and settings. As a result, after turning the ignition switch off, wait 90 seconds or more before disconnecting the cable from the negative (-) battery terminal.
  2. Some systems need to be initialized after the cable is reconnected (Click here).



2. PLACE FRONT WHEELS FACING STRAIGHT AHEAD


3. REMOVE FRONT WHEELS


4. REMOVE NO. 1 ENGINE UNDER COVER


5. SEPARATE NO. 2 INTERMEDIATE SHAFT ASSEMBLY


C155151E01
  1. Put matchmarks on the No. 2 steering intermediate shaft and the power steering gear.

  1. Remove the bolt and No. 2 steering intermediate shaft from the power steering gear.



6. DISCONNECT TIE ROD END SUB-ASSEMBLY LH
  1. Remove the cotter pin and nut.



    C179622E01
  1. Using SST, disconnect the tie rod end LH from the steering knuckle.

    SST
    09610-20012  

    NOTICE:
    1. Do not damage the front disc brake dust cover.
    2. Do not damage the ball joint dust cover.
    3. Do not damage the steering knuckle.



7. DISCONNECT TIE ROD END SUB-ASSEMBLY RH

HINT:
Use the same procedures described for the LH side.



8. DISCONNECT PRESSURE FEED TUBE ASSEMBLY


C159507E02
  1. Using union nut wrench, disconnect the pressure feed tube (return tube side) from the power steering gear.



    C159508E02
  1. Using union nut wrench, disconnect the pressure feed tube (pressure feed tube side) from the power steering gear.



    C159509
  1. Remove the 2 bolts and disconnect the pressure feed tube clamp.



9. REMOVE POWER STEERING GEAR ASSEMBLY


C161137E01
  1. Remove the 2 bolts, 2 nuts and power steering gear.

    NOTICE:
    Because the nut has its own stopper, do not turn the nut. Loosen the bolt with the nut fixed.