Home › ENGINE ยท 2UZ-FE › FUEL › FUEL PRESSURE REGULATOR

FUEL PRESSURE REGULATOR > INSTALLATION

for Preparation Click here



1. INSTALL FUEL PRESSURE REGULATOR


    A159726
  1. Apply a light coat of gasoline to a new O-ring, and install it to the pressure regulator.

  1. While turning the pressure regulator to the left and right, install it to the delivery pipe.



    A159711
  1. Install the pressure regulator with the 2 bolts.

    Torque:
    7.5 N*m{ 76 kgf*cm , 66 in.*lbf }

  1. Connect the fuel return hose to the pressure regulator.



    A159710
  1. Connect the vacuum sensing hose to the pressure regulator.



2. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
Some systems need to be initialized after the cable is reconnected (Click here).



3. CHECK FOR FUEL LEAK
  1. Connect the Techstream to the DLC3.

  1. Turn the ignition switch to ON and Techstream main switch ON.

    NOTICE:
    Do not start the engine.

  1. Enter the following menus: Powertrain / Engine and ECT / Active Test / Control the Fuel Pump / Speed.

  1. Check that there are no fuel leaks after doing maintenance anywhere on the fuel system.