Home › ENGINE ยท 3UR-FBE › FUEL › FUEL PRESSURE REGULATOR (for High Pressure)

FUEL PRESSURE REGULATOR (for High Pressure) > INSTALLATION

for Preparation Click here



1. INSTALL FUEL PRESSURE REGULATOR ASSEMBLY
  1. Apply a light coat of gasoline or spindle oil to a new O-ring and install it to the pressure regulator.

    NOTICE:
    1. Make sure that there are no scratches or foreign matter in or around the hole of the delivery pipe.
    2. When installing the injector, be careful not to damage the O-ring.



    A161402
  1. While turning the pressure regulator left and right, install it to the delivery pipe.



    A161401
  1. Install the 2 bolts.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }



    A161400
  1. Connect the vacuum sensing hose to the pressure regulator.



    A161399
  1. Connect the No. 2 fuel tube to the pressure regulator (Click here).



2. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable some systems need to be initialized after the cable is reconnected (Click here).



3. INSTALL AIR CLEANER HOSE ASSEMBLY


    A187008
  1. Install the air cleaner hose with the 2 clamps.

    Torque:
    4.0 N*m{ 41 kgf*cm , 35 in.*lbf }

  1. Connect the vacuum hose and ventilation hose.



4. INSTALL V-BANK COVER


    A165576E02
  1. Attach the 2 V-bank cover hooks to the bracket. Then align the 2 V-bank cover grommets with the 2 pins, and press down on the V-bank cover to attach the pins.



5. INSPECT FOR FUEL LEAK
  1. Connect the Techstream to the DLC3.

  1. Turn the ignition switch to on and Techstream main switch on.

    NOTICE:
    Do not start the engine.

  1. Enter the following menus: Powertrain / Engine and ECT / Active Test / Control the Fuel Pump / Speed.

  1. Check that there are no fuel leaks after doing maintenance anywhere on the fuel system.