Home › ENGINE ยท 3UR-FBE › FUEL › FUEL PRESSURE REGULATOR (for High Pressure)

FUEL PRESSURE REGULATOR (for High Pressure) > REMOVAL

for Preparation Click here



1. DISCHARGE FUEL SYSTEM PRESSURE

CAUTION:
  1. Do not disconnect any part of the fuel system until you have discharged the fuel system pressure.
  2. After discharging the fuel pressure, place a cloth or equivalent over fittings as you separate them to reduce the risk of fuel spray on yourself or in the engine compartment.

  1. Disconnect the cable from the negative (-) battery terminal.

    NOTICE:
    1. When disconnecting the cable some systems need to be initialized after the cable is reconnected (Click here).
    2. After the ignition switch is turned off, the navigation system requires approximately 90 seconds to record various types of memory and settings. As a result, after turning the ignition switch off, wait 90 seconds or more before disconnecting the cable from the negative (-) battery terminal.



    A194647
  1. Disconnect the 2 fuel pump ECU connectors.

  1. Connect the cable to the negative (-) battery terminal.

  1. Start the engine. After the engine has stopped on its own, turn the ignition switch off.

    HINT:
    DTC P0171/0174 (system too lean) may be set.

  1. Crank the engine again, then check that the engine does not start.

  1. Loosen the fuel tank cap, then discharge the pressure in the fuel tank completely.

  1. Connect the 2 fuel pump ECU connectors.



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
  1. When disconnecting the cable some systems need to be initialized after the cable is reconnected (Click here).
  2. After the ignition switch is turned off, the navigation system requires approximately 90 seconds to record various types of memory and settings. As a result, after turning the ignition switch off, wait 90 seconds or more before disconnecting the cable from the negative (-) battery terminal.



3. REMOVE V-BANK COVER


    A165576E01
  1. Raise the front of the V-bank cover to detach the 2 pins. Then remove the 2 V-bank cover hooks from the bracket, and remove the V-bank cover.



4. REMOVE AIR CLEANER HOSE ASSEMBLY


    A162102E01
  1. Disconnect the vacuum hose and ventilation hose.

  1. Loosen the 2 clamps.

  1. Remove the air cleaner hose.



5. REMOVE FUEL PRESSURE REGULATOR ASSEMBLY


    A161399
  1. Disconnect the No. 2 fuel tube from the pressure regulator (Click here).

    CAUTION:
    Put a cloth or equivalent under the pressure regulator.



    A161400
  1. Disconnect the vacuum sensing hose from the pressure regulator.



    A161401
  1. Remove the 2 bolts and the pressure regulator.

  1. Remove the O-ring from the pressure regulator.