Home › ENGINE ยท 1GR-FE › EMISSION CONTROL › CANISTER

CANISTER > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
  1. Some systems need to be initialized after the cable is reconnected (Click here).
  2. After the ignition switch is turned OFF, the navigation system requires approximately 90 seconds to record various types of memory and settings. As a result, after turning the ignition switch OFF, wait 90 seconds or more before disconnecting the cable from the negative (-) battery terminal.



2. REMOVE CANISTER ASSEMBLY


    A147034
  1. Remove the nut and disconnect the wiring harness clamp bracket.



    A155876E01
  1. Disconnect the pump module connector.

  1. Disconnect the purge line hose.

  1. Disconnect the air inlet line hose.

    1. Push the hose firmly toward the canister side.

    2. Pinch the hose (portion A) as shown in the illustration.

    3. Pull out the hose.

      NOTICE:
      1. Do not use any tools in this procedure.
      2. Check for any dirt and foreign matter contamination in the canister and around the hose. Clean if necessary. Foreign matter may damage the O-rings or cause leaks in the seal between the canister and hose.

  1. Disconnect the vent line hose.

    1. Pinch the retainer and then raise it.

      NOTICE:
      1. Do not use any tools in this procedure.
      2. Check for any dirt and foreign matter contamination in the valve and around the connector. Clean if necessary. Foreign matter may damage the O-rings or cause leaks in the seal between the valve and connector.



    A147033
  1. Disconnect the wire harness clamp.



    A147035
  1. Remove the 4 bolts and canister.