Home › ENGINE ยท 1GR-FE › ENGINE CONTROL SYSTEM › SFI SYSTEM

DTC    P0657    Actuator Supply Voltage Circuit / Open

for Preparation Click here


DESCRIPTION

The ECM monitors the output voltage to the throttle actuator. This self-check ensures that the ECM is functioning properly. The output voltage is usually 0 V when the ignition switch is turned OFF. If the output voltage is higher than 7 volts when the ignition switch is turned OFF, the ECM will illuminate the MIL and set a DTC when the ignition switch is turned ON.

DTC Code
DTC Detection Condition
Trouble Area
P0657
Throttle actuator power supply error
ECM

MONITOR STRATEGY


Related DTCs
None
Required sensors/Components (Main)
ECM
Required sensors/Components (Related)
Throttle actuator
Frequency of operation
Once per driving cycle
Duration
Within 1 second
MIL operation
Immediate
Sequence of operation
None

TYPICAL ENABLING CONDITIONS


Ignition switch
ON to OFF

TYPICAL MALFUNCTION THRESHOLDS


Throttle actuator power supply
7 V or more

INSPECTION PROCEDURE

HINT:
Read freeze frame data using the Techstream. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air-fuel ratio was lean or rich, and other data from the time the malfunction occurred.

1.CHECK DTC
  1. Clear DTC (Click here).

  1. Turn the ignition switch OFF.

  1. Disconnect the cable from the battery negative (-) terminal and wait for 1 minute.

  1. Connect the cable to the battery negative (-) terminal.

  1. Turn the ignition switch ON for 10 seconds.

  1. Turn the ignition switch OFF.

  1. Turn the ignition switch ON.

  1. Connect the Techstream to the DLC3.

  1. Turn the Techstream ON.

  1. Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.

  1. Check DTC.

    OK:
    P0657 is not present.



NG
REPLACE ECM (Click here)
OK

CHECK FOR INTERMITTENT PROBLEMS (Click here)