Home › ENGINE ยท 2UZ-FE › ENGINE CONTROL SYSTEM › SFI SYSTEM

DTC    P0657    Actuator Supply Voltage Circuit / Open

for Preparation Click here


DESCRIPTION

The ECM monitors the output voltage to the throttle actuator. This self-check ensures that the ECM is functioning properly. The output voltage usually is 0 V when the ignition switch is turned off. If the output voltage is higher than 7 V when the ignition switch is turned off, the ECM will illuminate the MIL and set a DTC when the ignition switch is turned to ON.

DTC Code
DTC Detection Condition
Trouble Area
P0657
Throttle actuator power supply error
ECM

MONITOR STRATEGY


Related DTCs
None
Required Sensors/Components (Main)
ECM
Required Sensors/Components (Related)
Throttle actuator
Frequency of operation
Once per driving cycle
Duration
Within 1 second
MIL operation
Immediate
Sequence of operation
None

TYPICAL ENABLING CONDITIONS


Ignition switch
From ON to OFF

TYPICAL MALFUNCTION THRESHOLDS


Throttle actuator power supply
7 V or higher

INSPECTION PROCEDURE

1.CHECK DTC
  1. Clear DTC (Click here).

  1. Turn the ignition switch off.

  1. Disconnect the cable from the negative battery terminal and wait for 1 minute.

  1. Connect the cable to the negative battery terminal.

  1. Turn the ignition switch to ON for 10 seconds.

  1. Turn the ignition switch off.

  1. Turn the ignition switch to ON.

  1. Check DTC.

    OK:
    P0657 is not present.



NG
REPLACE ECM (Click here)
OK

INTERMITTENT PROBLEMS (Click here)