Home › ENGINE ยท 3UR-FBE › ENGINE CONTROL SYSTEM › SFI SYSTEM

DTC    P0657    Actuator Supply Voltage Circuit / Open

for Preparation Click here


DESCRIPTION

The ECM monitors the output voltage to the throttle actuator. This self-check ensures that the ECM is functioning properly. The output voltage usually is 0 V when the ignition switch is turned off. If the output voltage is higher than 7 V when the ignition switch is turned off, the ECM will illuminate the MIL and store a DTC when the ignition switch is turned to ON.

DTC No.
DTC Detection Condition
Trouble Area
P0657
Throttle actuator power supply error
ECM

MONITOR STRATEGY


Related DTCs
None
Required sensors / components (main)
ECM
Required sensors / components (sub)
Throttle actuator
Frequency of operation
Once per driving cycle
Duration
Within 1 second
MIL operation
Immediate
Sequence of operation
None

TYPICAL ENABLING CONDITIONS


Ignition switch
From ON to off

TYPICAL MALFUNCTION THRESHOLDS


Throttle actuator power supply
7 V or more

INSPECTION PROCEDURE

1.CHECK DTC
  1. Clear DTC (Click here).

  1. Turn the ignition switch off.

  1. Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.

  1. Connect the cable to the negative (-) battery terminal.

  1. Turn the ignition switch to ON for 10 seconds.

  1. Turn the ignition switch off.

  1. Turn the ignition switch to ON.

  1. Check DTC.

    OK:
    P0657 is not present.



NG
REPLACE ECM (Click here)
OK

INTERMITTENT PROBLEMS (Click here)