Home › SUSPENSION & AXLE › TIRE AND WHEEL › TIRE PRESSURE WARNING ECU

TIRE PRESSURE WARNING ECU > INSTALLATION

for Preparation Click here



1. INSTALL TIRE PRESSURE WARNING ECU


    C153802
  1. Install the ECU with the 2 nuts.

    Torque:
    7.5 N*m{ 76 kgf*cm , 66 in.*lbf }

  1. Connect the ECU connector.



2. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY RH


    B160593
  1. Attach the 3 claws to install the finish panel.

  1. Install the 3 screws.

  1. Install the bolt.



3. INSTALL INSTRUMENT SIDE PANEL RH


    B163940
  1. Attach the 6 claws to install the side panel.



4. INSTALL COWL SIDE TRIM BOARD RH
  1. Install the cowl side trim board RH .

    HINT:
    Use the same procedures described for the LH side.



5. INSTALL FRONT DOOR SCUFF PLATE RH (for Double Cab, for CrewMax)
  1. Install the front door scuff plate RH .

    HINT:
    Use the same procedures described for the LH side.



6. INSTALL FRONT DOOR SCUFF PLATE RH (for Regular Cab)
  1. Install the front door scuff plate RH .

    HINT:
    Use the same procedures described for the LH side.



7. REGISTRATION OF TRANSMITTER ID
  1. Register the transmitter ID (Click here).



8. PERFORM INITIALIZATION
  1. Perform initialization (Click here).

    NOTICE:
    Be sure to inflate all tires to the proper inflation pressure before initialization.



9. CHECK TIRE PRESSURE AFTER REPAIRS
  1. After repairs, confirm that the actual tire pressures are displayed in the DATA LIST (Click here).