Home › ENGINE ยท 2UZ-FE › ENGINE CONTROL SYSTEM › SFI SYSTEM

DTC    P0604    Random Access Memory (RAM)

for Preparation Click here


DESCRIPTION

The ECM continuously monitors its internal memory status. This self-check ensures that the ECM functioning properly. This is diagnosed by internal "mirroring" of the main CPU and sub CPU to detect the Random Access Memory (RAM) errors. If outputs from these CPUs are different and deviate from the standard, the ECM will illuminate the MIL and set a DTC immediately.

DTC Code
DTC Detection Condition
Trouble Area
P0604
ECM RAM errors
ECM

MONITOR STRATEGY


Related DTCs
None
Required Sensors/Components (Main)
ECM
Required Sensors/Components (Related)
None
Frequency of operation
Continuous
Duration
16 seconds
MIL operation
Immediate
Sequence of operation
None

TYPICAL ENABLING CONDITIONS


None
-

TYPICAL MALFUNCTION THRESHOLDS


Main CPU and sub CPU mirroring
Fail

INSPECTION PROCEDURE

1.CHECK DTC
  1. Clear DTC (Click here).

  1. Turn the ignition switch off.

  1. Disconnect the cable from the negative battery terminal and wait for 1 minute.

  1. Connect the cable to the negative (-) battery terminal.

  1. Turn the ignition switch to ON.

  1. Check DTC.

    OK:
    P0604 is not present.



NG
REPLACE ECM (Click here)
OK

CHECK FOR INTERMITTENT PROBLEMS (Click here)