NAVIGATION SYSTEM (for CrewMax) > Vehicle Speed Signal Circuit between Navigation Receiver Assembly and Combination Meter |

| 1.CHECK OPERATION OF SPEEDOMETER |
Drive the vehicle and check if the function of the speedometer in the combination meter is normal.
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER - COMBINATION METER) |
![]() |
Disconnect the K6 receiver connector.
Disconnect the J28 meter connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| K6-3 (SPD) - J28-35 (+S) | Always | Below 1 Ω |
| K6-3 (SPD) - Body ground | Always | 10 kΩ or higher |
| Result | Proceed to |
| OK (for Column Shift Type) | A |
| OK (for Floor Shift Type) | B |
| NG | C |
|
| ||||
|
| ||||
| A | ||
| ||