Home › COMMUNICATION SYSTEM › MULTIPLEX COMMUNICATION › LIN COMMUNICATION SYSTEM

LIN COMMUNICATION SYSTEM > Integration Control and Panel Assembly Communication Error

for Preparation Click here


DESCRIPTION

The LIN communication of the components related to the mirror heater occurs between the air conditioning amplifier (A/C ECU) and integration control and panel.

WIRING DIAGRAM


B166129E01


INSPECTION PROCEDURE

NOTICE:
When using the Techstream with the ignition switch OFF to troubleshoot:
Connect the Techstream to the vehicle, and turn a courtesy switch on and off at 1.5 second intervals until communication between the tester and vehicle begins.

1.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER - INTEGRATION CONTROL AND PANEL)
B166138E01
  1. Disconnect the J37 panel connector.

  1. Disconnect the J19 amplifier connector.

  1. Measure the resistance and voltage according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    J19-37 (LIN1) - J37-3 (STX)
    Always
    Below 1 Ω
    J19-37 (LIN1) or J37-3 (STX) - Body ground
    Always
    10 kΩ or higher

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    J19-37 (LIN1) or J37-3 (STX) - Body ground
    Always
    Below 1 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.CHECK HARNESS AND CONNECTOR (INTEGRATION CONTROL AND PANEL - BATTERY AND BODY GROUND)


    B166140E01
  1. Disconnect the J37 panel connector.

  1. Measure the resistance and voltage according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    J37-1 (GND) - Body ground
    Always
    Below 1 Ω

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    J37-16 (IG+) - Body ground
    Ignition switch ON
    11 to 14 V
    Ignition switch OFF
    Below 1 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.CHECK INTEGRATION CONTROL AND PANEL ASSEMBLY (OPERATION)
  1. Temporarily replace the integration control and panel with a new or normally functioning one.

    1. For Column Shift Type, refer to the following procedures (Click here).

    2. For Floor Shift Type, refer to the following procedures (Click here).

  1. Check that the malfunction disappears.

    OK:
    Malfunction disappears.



NG
REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY (Click here)
OK

END (INTEGRATION CONTROL AND PANEL ASSEMBLY IS DEFECTIVE)