Home › BODY ELECTRICAL › METER › COMBINATION METER

COMBINATION METER > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
  1. After the ignition switch is turned OFF, the navigation system requires approximately 90 seconds to record various types of memory and settings. As a result, after turning the ignition switch OFF, wait 90 seconds or more before disconnecting the cable from the negative (-) battery terminal.
  2. Some systems need to be initialized after the cable is reconnected (Click here).



2. REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY


    E145052
  1. Detach the 4 claws.



    E145049
  1. for Column Shift Type:
    Move the shift lever to the S position.

  1. Detach the 12 clips.

  1. Disconnect the connectors and clamps.



  1. Remove the wire harness from the slots, and then remove the finish panel.


    E145053E01



3. REMOVE COMBINATION METER ASSEMBLY


    E141677
  1. Remove the 4 screws.



    E141678
  1. Disconnect the connector and clamp, and remove the combination meter.