POWER DOOR LOCK CONTROL SYSTEM > Rear Door UNLOCK Detection Switch LH Circuit |

| 1.READ VALUE USING TECHSTREAM (UNLOCK DETECTION SWITCH) |
Check the Data List to ensure proper functioning of the unlock detection switch.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| RL-Door Lock Pos SW | Rear door unlock detection switch LH signal / ON or OFF | ON: Rear left door is unlocked OFF: Rear left door is locked | - |
|
| ||||
| OK | ||
| ||
| 2.INSPECT REAR DOOR LOCK MOTOR ASSEMBLY LH (UNLOCK DETECTION SWITCH) |
![]() |
Remove the rear door lock motor LH (Click here).
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| 9 (E) - 6 (LSSR) | Lock | 10 kΩ or higher |
| Unlock | Below 1 Ω |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (REAR DOOR LOCK MOTOR LH - MAIN BODY ECU AND BODY GROUND) |
![]() |
Disconnect the O10 door lock connector.
Disconnect the DC ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| O10-6 (LSSR) - DC-1 (LSWL) | Always | Below 1 Ω |
| O10-6 (LSSR) - Body ground | Always | 10 kΩ or higher |
| O10-9 (E) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | ||
| ||