REAR BUMPER (for Resin Type Bumper) > INSTALLATION |
| 1. INSTALL NO. 3 WIRE FRAME (w/ Trailer Towing System) |
![]() |
Install the wire frame with the 2 bolts.
Attach the clamp.
Connect the connector.
| 2. INSTALL REAR BUMPER SIDE EXTENSION SUB-ASSEMBLY LH |
![]() |
Install the side extension with the 3 screws and bolt.
| 3. INSTALL REAR BUMPER SIDE EXTENSION SUB-ASSEMBLY RH |
| 4. INSTALL REAR BUMPER NO. 1 SUPPORT |
![]() |
Install the bumper support.
| 5. INSTALL REAR BUMPER PAD SUB-ASSEMBLY |
![]() |
Install the bumper pad with the 6 bolts.
| 6. INSTALL REAR BUMPER COVER |
Attach the 4 claws to install the bumper cover.
Install the 4 bolts and 2 nuts.
Install the 2 clips and 4 screws.

w/ Intuitive Parking Assist System:
Connect the connector and clamps shown in illustration.

| 7. INSTALL LICENSE PLATE LIGHT ASSEMBLY LH |
![]() |
Attach the claw to install the license plate light.
Install the screw.
| 8. INSTALL LICENSE PLATE LIGHT ASSEMBLY RH |
| 9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |