Home › ENGINE ยท 1GR-FE › ENGINE CONTROL SYSTEM › HEATED OXYGEN SENSOR

HEATED OXYGEN SENSOR > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
  1. Some systems need to be initialized after the cable is reconnected (Click here).
  2. After the ignition switch is turned OFF, the navigation system requires approximately 90 seconds to record various types of memory and settings. As a result, after turning the ignition switch OFF, wait 90 seconds or more before disconnecting the cable from the negative (-) battery terminal.



2. REMOVE FRONT NO. 3 EXHAUST PIPE SUB-ASSEMBLY (for Regular Cab Standard Deck)
  1. Remove the 4 bolts and 2 nuts.

  1. Disconnect the exhaust pipe from the exhaust pipe support, and remove the 2 gaskets.



3. REMOVE FRONT NO. 2 EXHAUST PIPE ASSEMBLY (for Regular Cab Standard Deck)
  1. Disconnect the air fuel ratio sensor connector.

  1. Disconnect the heated oxygen sensor connector.

  1. Remove the 3 nuts, exhaust pipe and gasket.



4. REMOVE FRONT NO. 2 EXHAUST PIPE ASSEMBLY (except Regular Cab Standard Deck)
  1. Disconnect the air fuel ratio sensor connector.

  1. Disconnect the heated oxygen sensor connector.

  1. Remove the 3 nuts, 2 bolts, exhaust pipe and gasket.



5. REMOVE FRONT EXHAUST PIPE ASSEMBLY
  1. Disconnect the air fuel ratio sensor connector.

  1. Disconnect the heated oxygen sensor connector and 2 clamps.

  1. Remove the 2 bolts.

  1. Remove the 3 nuts, exhaust pipe and 2 gaskets.



6. REMOVE HEATED OXYGEN SENSOR (for Bank 1 Sensor 2)


    A155873E01
  1. Using SST, remove the sensor.

    SST
    09224-00010  



7. REMOVE HEATED OXYGEN SENSOR (for Bank 2 Sensor 2)


    A155869E01
  1. Using SST, remove the sensor.

    SST
    09224-00010