Home › ENGINE · 3UR-FE › STARTING › STARTER RELAY

STARTER RELAY > ON-VEHICLE INSPECTION

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
  1. Some systems need to be initialized after the cable is reconnected (Click here).
  2. After the ignition switch is turned OFF, the navigation system requires approximately 90 seconds to record various types of memory and settings. As a result, after turning the ignition switch OFF, wait 90 seconds or more before disconnecting the cable from the negative (-) battery terminal.



2. REMOVE STARTER RELAY (ST)
  1. Remove the engine room relay box cover.

  1. Remove the starter relay from the engine room relay block.



3. INSPECT STARTER RELAY


    B060778E26
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Terminal Connection
    Condition
    Specified Condition
    3 - 5
    When battery voltage is not applied to terminals 1 and 2
    10 kΩ or higher
    When battery voltage is applied to terminals 1 and 2
    Below 1 Ω

    If the result is not as specified, replace the relay.



4. INSTALL STARTER RELAY


5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
Some systems need to be initialized after the cable is reconnected (Click here).