Home › ENGINE · 3UR-FE › STARTING › ACC RELAY

ACC RELAY > ON-VEHICLE INSPECTION

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
  1. Some systems need to be initialized after the cable is reconnected (Click here).
  2. After the ignition switch is turned OFF, the navigation system requires approximately 90 seconds to record various types of memory and settings. As a result, after turning the ignition switch OFF, wait 90 seconds or more before disconnecting the cable from the negative (-) battery terminal.



2. INSPECT MAIN BODY ECU (ACC RELAY)



A160907E01

  1. Measure the resistance of the ACC relay circuit.

    1. Measure the resistance according to the value(s) in the table below.

      Standard resistance:
      Tester Connection
      Condition
      Specified Condition
      DD-47 - DD-8
      When battery voltage is not applied between DD-45 and DD-62
      10 kΩ or higher
      When battery voltage is applied between DD-45 and DD-62
      Below 1 Ω

      If the result is not as specified, replace the main body ECU.



3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
Some systems need to be initialized after the cable is reconnected (Click here).