Home › ENGINE ยท 2UZ-FE › FUEL › FUEL PRESSURE PULSATION DAMPER

FUEL PRESSURE PULSATION DAMPER > INSTALLATION

for Preparation Click here



1. INSTALL FUEL PRESSURE PULSATION DAMPER


    A162691E01
  1. Install 2 new gaskets and the fuel main hose with the fuel pressure pulsation damper.

    NOTICE:
    Make sure to install the gaskets in the order shown in the illustration, as the shape of the upper side and lower side gaskets is different.



    A067124E01
  1. Using SST, tighten the union bolt.

    SST
    09612-24014  

    Torque:
    with SST:
    33 N*m{ 340 kgf*cm , 24 ft.*lbf }
    without SST:
    39 N*m{ 398 kgf*cm , 29 ft.*lbf }

    HINT:
    1. Use a torque wrench with a fulcrum length of 30 cm (11.8 in.).
    2. Make sure SST and wrench are connected in a straight line.



2. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
Some systems need to be initialized after the cable is reconnected (Click here).



3. CHECK FOR FUEL LEAK
  1. Connect the Techstream to the DLC3.

  1. Turn the ignition switch to ON and Techstream main switch ON.

    NOTICE:
    Do not start the engine.

  1. Enter the following menus: Powertrain / Engine and ECT / Active Test / Control the Fuel Pump / Speed.

  1. Check that there are no fuel leaks after doing maintenance anywhere on the fuel system.