Home › ENGINE ยท 2UZ-FE › LUBRICATION › OIL PRESSURE SWITCH

OIL PRESSURE SWITCH > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
  1. After the ignition switch is turned OFF, the navigation system requires approximately 90 seconds to record various types of memory and setting. As a result, after turning the ignition switch OFF, wait 90 seconds or more before disconnecting the cable from the negative (-) battery terminal.
  2. Some systems need to be initialized after the cable is reconnected (Click here).



2. REMOVE NO. 1 ENGINE UNDER COVER


    A150108
  1. Remove the 3 screws and 5 bolts.

  1. Unhook the engine under cover from the vehicle body as shown in the illustration.



3. REMOVE OIL PRESSURE SENDER GAUGE ASSEMBLY
  1. Disconnect the sender gauge connector.



    A160793
  1. Remove the sender gauge.