Home › ENGINE ยท 1GR-FE › EMISSION CONTROL › PURGE VALVE

PURGE VALVE > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
  1. Some systems need to be initialized after the cable is reconnected (Click here).
  2. After the ignition switch is turned OFF, the navigation system requires approximately 90 seconds to record various types of memory and settings. As a result, after turning the ignition switch OFF, wait 90 seconds or more before disconnecting the cable from the negative (-) battery terminal.



2. REMOVE V-BANK COVER


    A112983E03
  1. Remove the 2 nuts and V-bank cover.



3. REMOVE PURGE VSV


A157597
  1. Disconnect the purge VSV connector.

  1. Disconnect the 2 purge line hoses.



    A157598
  1. Remove the bolt and purge VSV.