Home › ENGINE ยท 1GR-FE › EMISSION CONTROL › AIR PUMP

AIR PUMP > INSTALLATION

for Preparation Click here



1. INSTALL AIR PUMP ASSEMBLY


A158513E01
  1. Insert the slot over the stud and bracket tab into the slot (View A).

  1. Insert the bracket tab into the slot (View B).

  1. Install the 2 bolts and 2 nuts.

    Torque:
    for bolt:
    18 N*m{ 184 kgf*cm , 13 ft.*lbf }
    for nut:
    12 N*m{ 122 kgf*cm , 9 ft.*lbf }



2. INSTALL NO. 2 AIR INJECTION SYSTEM HOSE
  1. Install the air injection system hose as shown in the illustration.



3. INSTALL NO. 3 AIR INJECTION SYSTEM HOSE


  1. Install the air injection system hose as shown in the illustration.


    A158852E01



    A153463
  1. Connect the 2 connectors.

  1. Connect the 2 connector clamps.



    A153461
  1. Install the fender apron seal with the 2 clips.



4. INSTALL FRONT FENDER LINER RH


    A160255
  1. Install the fender liner with the 9 clips.



5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
Some systems need to be initialized after the cable is reconnected (Click here).