Home › ENGINE ยท 1GR-FE › EMISSION CONTROL › AIR PUMP

AIR PUMP > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
  1. Some systems need to be initialized after the cable is reconnected (Click here).
  2. After the ignition switch is turned OFF, the navigation system requires approximately 90 seconds to record various types of memory and settings. As a result, after turning the ignition switch OFF, wait 90 seconds or more before disconnecting the cable from the negative (-) battery terminal.



2. REMOVE FRONT FENDER LINER RH


    A160255
  1. Remove the 9 clips and fender liner.



3. REMOVE NO. 3 AIR INJECTION SYSTEM HOSE


    A153461
  1. Using a clip remover, remove the 2 clips.

  1. Fold back the fender apron seal.



    A153463
  1. Disconnect the 2 connectors.

  1. Disconnect the 2 connector clamps.



    A153462
  1. Detach the 2 clamps.



    A153464E01
  1. Detach the 2 bracket clips and remove the No. 3 air injection system hose.



4. REMOVE NO. 2 AIR INJECTION SYSTEM HOSE
  1. Detach the bracket clip and remove the No. 2 air injection system hose.



5. REMOVE AIR PUMP ASSEMBLY


    A153465
  1. Remove the 2 bolts, 2 nuts and air pump.