Home › SECURITIES › ENGINE IMMOBILISER › ENGINE IMMOBILISER SYSTEM

DTC    B279A    Theft Deterrent System Communication Line High Fixation

for Preparation Click here


DESCRIPTION

If the communication line (EFIO-IMI) to the transponder key ECU is stuck on HI output, the ECM outputs this DTC.

DTC No.
DTC Detection Condition
Trouble Area
B279A
When communication line (EFIO-IMI) between ECM and transponder key ECU is stuck on HI output for 6 seconds or more
  1. Harness or connector
  2. Transponder key ECU
  3. ECM

WIRING DIAGRAM


B160072E03


INSPECTION PROCEDURE

1.CLEAR DTC
  1. Clear the DTC (Click here).


NEXT


2.CHECK FOR DTC
  1. Check for DTC (Click here).
    Result 
    Result
    Proceed to
    DTC B279A is output
    A
    DTC B279A and other DTCs are output
    B

    HINT:
    If any DTCs other than B279A are output, troubleshoot those DTCs first.



B
GO TO DIAGNOSTIC TROUBLE CODE CHART (Click here)
A


3.CHECK HARNESS AND CONNECTOR (TRANSPONDER KEY ECU - ECM)


    B129773E04
  1. Disconnect the J26 ECU connector.

  1. Disconnect the A24 ECM connector.

  1. Measure the resistance and voltage according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    J26-13 (EFIO) - A24-40 (IMI)
    Always
    Below 1 Ω
    J26-13 (EFIO) or A24-40 (IMI) - Body ground
    Always
    10 kΩ or higher

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    J26-13 (EFIO) - Body ground
    Always
    Below 1 V
    A24-40 (IMI) - Body ground



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4.CHECK TRANSPONDER KEY ECU (OUTPUT)
Click here


    B169769E01
  1. Measure waveform.
    Waveform 1 (Reference) 
    Terminal No. (Symbols)
    Tool Setting
    Switch Condition
    J26-13 (EFIO) - J26-16 (GND)
    10 V/DIV., 500 msec./DIV.
    Ignition switch ON

    OK:
    Waveform is output normally (see illustration).

    Result 
    Result
    Proceed to
    Waveform is not output normally
    A
    Waveform is output normally (for 2UZ-FE)
    B
    Waveform is output normally (for 3UR-FE)
    C
    Waveform is output normally (for 3UR-FBE)
    D



B
REPLACE ECM (Click here)

C
REPLACE ECM (Click here)

D
REPLACE ECM (Click here)
A


5.CHECK TRANSPONDER KEY ECU (POWER SOURCE AND BODY GROUND)
B128338E16
  1. Turn the ignition switch ON.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    J26-1 (+B) - J26-16 (GND)
    Always
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE TRANSPONDER KEY ECU (Click here)