Home › BODY › SEAT › FRONT SEAT ASSEMBLY (for Manual Seat)

FRONT SEAT ASSEMBLY (for Manual Seat) > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedures for the LH side and RH side.
  2. The procedures listed below are for the LH side.



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

NOTICE:
  1. Some systems need to be initialized after the cable is reconnected (Click here).
  2. After the ignition switch is turned OFF, the navigation system requires approximately 90 seconds to record various types of memory and settings. As a result, after turning the ignition switch OFF, wait 90 seconds or more before disconnecting the cable from the negative (-) battery terminal.



2. REMOVE INNER FRONT SEAT TRACK COVER LH REAR
  1. Operate the seat track adjusting handle to move the seat to the foremost position.



    B165515
  1. Using a screwdriver, detach the 2 claws and remove the seat track cover.

    HINT:
    Tape the screwdriver tip before use.



3. REMOVE OUTER FRONT SEAT TRACK COVER LH REAR


B165516
  1. Using a screwdriver, detach the 2 claws and remove the seat track cover.

    HINT:
    Tape the screwdriver tip before use.



4. REMOVE FRONT SEAT ASSEMBLY LH


    B165517
  1. Remove the 2 bolts.

  1. Operate the seat track adjusting handle to move the seat to the rearmost position.



    B165518
  1. Remove the 2 bolts.

  1. Operate the seat track adjusting handle to move the seat to the center position.

  1. Disconnect the seat wire connectors under the seat.

  1. Remove the front seat.

    NOTICE:
    Be careful not to damage the vehicle body.