Home › BODY › SEAT › FRONT SEAT ASSEMBLY (for Power Seat)

FRONT SEAT ASSEMBLY (for Power Seat) > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedures for the LH side and RH side.
  2. The procedures listed below are for the LH side.



1. REMOVE FRONT SEAT HEADREST ASSEMBLY LH


2. REMOVE INNER FRONT SEAT TRACK COVER LH REAR
  1. Operate the power seat switch to move the seat to the foremost position.



    B165515
  1. Using a screwdriver, detach the 2 claws and remove the seat track cover.

    HINT:
    Tape the screwdriver tip before use.



3. REMOVE OUTER FRONT SEAT TRACK COVER LH REAR


B165516
  1. Using a screwdriver, detach the 2 claws and remove the seat track cover.

    HINT:
    Tape the screwdriver tip before use.



4. REMOVE FRONT SEAT ASSEMBLY LH


B165517
  1. Operate the power seat switch to move the seat to the foremost position.

  1. Remove the 2 bolts.

  1. Operate the power seat switch to move the seat to the rearmost position.



    B166943
  1. Remove the 2 bolts.

  1. Operate the power seat switch to move the seat to the center position.



    B167188
  1. w/ Leg Support Adjustment Switch:
    Operate the leg support adjustment switch to move the seat cushion to the open position.

  1. Disconnect the cable from the negative (-) battery terminal.

    CAUTION:
    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

    NOTICE:
    1. Some systems need to be initialized after the cable is reconnected (Click here).
    2. After the ignition switch is turned OFF, the navigation system requires approximately 90 seconds to record various types of memory and settings. As a result, after turning the ignition switch OFF, wait 90 seconds or more before disconnecting the cable from the negative (-) battery terminal.

  1. Disconnect the seat wire connectors under the seat.

  1. Remove the front seat.