Home › BODY › SEAT › POWER SEAT SWITCH (w/o Seat Position Memory System)

POWER SEAT SWITCH (w/o Seat Position Memory System) > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedures for the LH side and RH side.
  2. The procedures listed below are for the LH side.



1. REMOVE FRONT SEAT ASSEMBLY LH
  1. Remove the front seat (Click here).



2. REMOVE SLIDE AND VERTICAL POWER SEAT SWITCH KNOB LH


B166941E01
  1. Apply protective tape around the cushion shield.

  1. Using a screwdriver, detach the 2 claws and remove the knob.

    HINT:
    Tape the screwdriver tip before use.



3. REMOVE RECLINING POWER SEAT SWITCH KNOB LH


B166942E01
  1. Using a screwdriver, detach the 2 claws and remove the knob.

    HINT:
    Tape the screwdriver tip before use.



4. REMOVE FRONT SEAT CUSHION SHIELD LH


    B166944E01
  1. Remove the hog rings and rubber bands of the seatback cover from the seat frame.

  1. Remove the 2 screws.



    B166945
  1. Remove the 3 screws.

  1. Detach the 2 claws and remove the cushion shield.

  1. Disconnect the switch connectors.



5. REMOVE LEG SUPPORT ADJUSTMENT SWITCH (w/ Leg Support Adjustment Switch)


B166947
  1. Detach the 2 wire harness clamps and remove the 2 screws and switch.

  1. Disconnect the switch connector.



6. REMOVE FRONT POWER SEAT SWITCH LH


B166949
  1. Disconnect the 2 connectors.

  1. w/o Seat Position Memory System:
    Disconnect the switch connector.

  1. Remove the 3 screws and switch.