Home › BODY › SEAT › FRONT POWER SEAT LUMBAR SWITCH (for Power Seat)

FRONT POWER SEAT LUMBAR SWITCH (for Power Seat) > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedures for the LH side and RH side.
  2. The procedures listed below are for the LH side.



1. REMOVE FRONT SEAT ASSEMBLY LH
  1. Remove the front seat (Click here).



2. REMOVE SLIDE AND VERTICAL POWER SEAT SWITCH KNOB LH


B166941E01
  1. Apply protective tape around the cushion shield.

  1. Using a screwdriver, detach the 2 claws and remove the knob.

    HINT:
    Tape the screwdriver tip before use.



3. REMOVE RECLINING POWER SEAT SWITCH KNOB LH


B166942E01
  1. Using a screwdriver, detach the 2 claws and remove the knob.

    HINT:
    Tape the screwdriver tip before use.



4. REMOVE FRONT SEAT CUSHION SHIELD LH


    B166944E01
  1. Remove the hog rings and rubber bands of the seatback cover from the seat frame.

  1. Remove the 2 screws.



    B166945
  1. Remove the 3 screws.

  1. Detach the 2 claws and remove the cushion shield.

  1. Disconnect the switch connectors.



5. REMOVE FRONT POWER SEAT LUMBAR SWITCH LH


B166946
  1. Remove the 2 screws and switch.