FRONT SEAT CUSHION HEATER (w/ Seat Heater System) > REMOVAL |
| 1. REMOVE FRONT SEAT ASSEMBLY LH |
Remove the front seat (Click here).
| 2. REMOVE SLIDE AND VERTICAL POWER SEAT SWITCH KNOB LH |
![]() |
Apply protective tape around the cushion shield.
Using a screwdriver, detach the 2 claws and remove the knob.
| 3. REMOVE RECLINING POWER SEAT SWITCH KNOB LH |
![]() |
Using a screwdriver, detach the 2 claws and remove the knob.
| 4. REMOVE FRONT SEAT CUSHION SHIELD LH |
![]() |
Remove the hog rings and rubber bands of the seatback cover from the seat frame.
Remove the 2 screws.
![]() |
Remove the 3 screws.
Detach the 2 claws and remove the cushion shield.
Disconnect the switch connectors.
| 5. REMOVE FRONT SEAT INNER BELT ASSEMBLY LH |
Driver Side:
Disconnect the 2 connectors and detach the 4 clamps.
Passenger Side:
Disconnect the connector and detach the clamp.
![]() |
Remove the nut and front seat inner belt.
| 6. REMOVE INNER FRONT SEAT CUSHION SHIELD LH |
![]() |
Remove the screw.
Detach the 2 claws and clip, and then remove the cushion shield.
| 7. REMOVE FRONT POWER SEAT SWITCH LH |
![]() |
Disconnect the 2 connectors.
w/o Seat Position Memory System:
Disconnect the switch connector.
Remove the 3 screws and switch.
| 8. REMOVE FRONT SEAT CUSHION COVER WITH PAD LH |
![]() |
Using a clip remover, remove the 2 clips.
![]() |
Disconnect the seat heater connector and detach the 2 wire harness clamps.
![]() |
Disconnect the seat heater control connector and detach the 2 wire harness clamps.
![]() |
Remove the hog rings and detach the hooks.
![]() |
Remove the seat cushion cover wire.
Remove the seat cushion cover with pad from the seat frame.
![]() |
w/o Leg Support Adjustment Switch:
Remove the hog rings.
Bend the 2 seat frame claws upward.
Detach the hooks and remove the seat cushion cover with pad.
| 9. REMOVE SEPARATE TYPE FRONT SEAT CUSHION COVER LH |
Remove the hog rings and front seat cushion cover.

![]() |
w/o Leg Support Adjustment Switch:
Remove the hog rings and front seat cushion cover.
| 10. REMOVE FRONT SEAT CUSHION HEATER ASSEMBLY LH |
![]() |
Cut off the tack pins which fasten the seat heater to the seat cushion cover, and then remove the seat cushion heater from the seat cushion cover.